Cineversity

Hello,
I’ve noticed that a lot of the Maxon trainers are on macs.
I am also using one and got a Sonnet Puk eGPU to use Redshift.
The eGPU works fine for that.
However, it seems to crash my whole system when I am using the Puck along with my Wacom Cintiq display, especially if I am doing anything with meshes or clones.

So, my question is, do you have any experience with a set-up like this? Are there particular settings I should be using to best work with C4D, the eGPU and the Cintiq?

I’ve tried the Sonnet support, but they aren’t super… supportive.

Thank you.

Hi ericksonk,

This is one of those problems where you sit between chairs, and everyone points to the other support. I know that pain. But to my understanding, you have not checked with the Maxon support:
https://www.maxon.net/en/support-center

Sorry for the delay. I was not able to post here for a few hours.
I’m not sure how well Wacom might be able to help you.

Questions to the Trainer team will work the best: training -a-t- maxon -d-o-t- net

My best wishes

Thanks Dr. Sassi.
I’ll keep digging.
Just keep hoping that there is a switch I haven’t clicked.
-KHE

Hi KHE,

I hope you find the solution that makes it work.

Fingers crossed.

All the best