Hi All,
I have a very basic “problem” (i guess) but I can’t find the right solution (on the net) yet.
I have a joint-chain with several joints. I want to access each of the contained joints in this chain via xpresso and address the angle-port of each joint via an user-data input.
My approaches were via hierachy and object-nodes but I couldn’t figure out how to address the angle-port of the joint as I only get object indexes without any joint-properties.
The aim is to adjust the bending of the joint-chain via user-data. As the chain is up to 100 joints I want to automate things instead of manually dragging a ton of objects into xpresso and link them all by hand
Edit: at the end, the chain should bend to an archimedical spiral, so each joint angle needs to be slightly iterated.
I hope you understand my intention.
Thanks and sunny regards,
Tom