Cineversity

Hi, this is weird i messed with any single parameter and some of the clones do not get affected by the linear field rotation. It might be a glitch only in R20 i get this kind of behavior, i ve had it in other scenes and i ignored it.
Take a look: https://www.dropbox.com/s/ls4d3f0rkrb7irv/cloner_dynamics_trigger.c4d?dl=0

thanks!!

Hi thanulee,

When the dynamic kicks in, any given movement will lose its non-dynamic influence. Dynamic takes over. In your example, the Linear Field slows down and doesn’t provide the needed impact for dynamics.

I have set up two ways to work with this, assuming I understand your target. I have also reduced your file to have only native Cinema 4D parts in it. See below the alert I got.
https://www.amazon.com/clouddrive/share/l7Re9tWpzvv1o94OBAfjoQOeAqBjvlnA7YSsIWUx5vE

The F-Curve of the Linear Field shows a substantial slow down towards its end, the needed trigger velocity is obviously no longer received.

Each version shows your spline interpolation first and then the effect of a linear movement in the next file.

First, I moved the rotation into an earlier state via the Matrix Object.
In the other set up, my preferred version, the Dynamics is active only when the Linear field selects those. You might set inside of the MoGraph Selection the Tolerance for the selection differently, to get your results.
The CV2_r20_drs_19_MGxd_11.c4d is the one I would suggest for the setup, the other files are for demo purposes only, but use any of the four if they work for you.

Scene files:
https://www.amazon.com/clouddrive/share/oUWJOUpyr15gtjeaiEqR4ZxygTjbUFGujg6cn5cfmdq

Cheers

thank u very much! i will take a close look! I solved this by ghost object and initial speed on dynamics tag, but i d like to understand whats going on here. Cause in my head i have operations like 1.mograph goes in then 2. dynamics get triggered. I was raising the numbers in plain effector as well to very high amounts and some of the clones still didnt move.

You’re very welcome, thanulle, thanks for the reply.

Enjoy your project.